The Work of a Mold Removal and Remediation Company

Do Not Be Afraid by the Men in the White Suits!

Just like any other harmful material, like eliminating lead-based paint or asbestos, for instance, mold removal remediation workers will completely dress for action. They will have N- 95 masks, white matches, booties, and goggles. Looking like guys from outer space. This does not necessarily suggest that the mold inspection and remediation company will be removing hazardous mold, however, all preventative measures are taken. This is the standard procedure for any job where they are dealing with dangerous products.

When handling Black Mold or any other color the remediation will follow a similar process to what is described listed below.

Here is what you need to expect:

Step One: We Need Access

We will have devices, plastic, and tape everywhere. So please keep the animals somewhere else and move vehicles from the driveway or garage, and clear wide gain access to from the outside to the mold area. The mold removal company will park a car as near as possible to the doorway, put down plastic sheeting, and run tubes through your house to the mold location. If the mold location is accessible from the outdoors (such as a crawlspace), it is so much the much better. A quality mold inspection removal company will make sure to keep your house clean while they do the work.

Step Two: Kill Mold with Biocide

The initial step of this process is to separate all contaminated areas from the staying spaces of the house. This is typically done with plastic sheeting and tape to make a barrier. The next step is to spray the mold location with a biocide. Biocide is an EPA-approved liquid that kills mold. Please Note that bleach is not approved by the EPA for eliminating mold. Usually, this primary step ought to take less time than the second step. After the employees leave, the biocide goes to work, killing the mold spores. The mold remediation company should spray well beyond the musty location to guarantee that no more mold grows. For example, if only a minimal area of an attic displays mold, the mold remediation company will probably still spray down the whole attic. This is more desirable, and you must confirm with the company this is the standard operating procedure.

Step Three: Remove the Mold

Generally the next day, the mold testing and remediation company return. Once again, clear access is needed. They start the job of removing the dead mold from its food source. This is generally part of your house. Numerous various methods can be used for this area. One crude and time-consuming method is sanding, scraping, and utilizing a wire brush. Others include media blasting this would consist of baking soda, solidified carbon dioxide, sand, and other types of media.

Step Four: Clean the location

Here is where a lot of the clean-up begins. When all the dead mold is removed from the substrate the location will need to vacuum with a HEPA (High-Efficiency particular air) filter attachment. This will allow all the mold spores that were launched when the mold was dying to be recorded and disposed of alone with the Mycotoxins and allergens associated.

Step Five: Spray Sealer to prevent Mold from Returning

The 2nd to the last step in the process is to treat the formerly impacted location with a sealer to prevent new or retaking place mold growth. The remediation company should spray an area greater than the affected area to guarantee it is covered. If an attic or crawlspace is included the entire area must be dealt with. This is an extremely important step in the process.

Step Six: Final Clean up

This is where all the plastic boils down and tape is eliminated. These must be cautiously taken down as to not disrupt were the mold spores may have landed. Once all the plastic and tape are removed the area will need to be HEPA vacuumed again and a spore count analysis required to validate that the house has regular levels of mold.